全文获取类型
收费全文 | 22376篇 |
免费 | 1708篇 |
国内免费 | 871篇 |
专业分类
电工技术 | 636篇 |
综合类 | 1284篇 |
化学工业 | 8670篇 |
金属工艺 | 1689篇 |
机械仪表 | 1293篇 |
建筑科学 | 627篇 |
矿业工程 | 616篇 |
能源动力 | 471篇 |
轻工业 | 2340篇 |
水利工程 | 190篇 |
石油天然气 | 1036篇 |
武器工业 | 104篇 |
无线电 | 1019篇 |
一般工业技术 | 3087篇 |
冶金工业 | 957篇 |
原子能技术 | 299篇 |
自动化技术 | 637篇 |
出版年
2024年 | 79篇 |
2023年 | 349篇 |
2022年 | 569篇 |
2021年 | 773篇 |
2020年 | 633篇 |
2019年 | 539篇 |
2018年 | 559篇 |
2017年 | 674篇 |
2016年 | 658篇 |
2015年 | 712篇 |
2014年 | 1041篇 |
2013年 | 1283篇 |
2012年 | 1526篇 |
2011年 | 1788篇 |
2010年 | 1296篇 |
2009年 | 1356篇 |
2008年 | 1109篇 |
2007年 | 1507篇 |
2006年 | 1400篇 |
2005年 | 1215篇 |
2004年 | 1072篇 |
2003年 | 897篇 |
2002年 | 718篇 |
2001年 | 634篇 |
2000年 | 491篇 |
1999年 | 446篇 |
1998年 | 327篇 |
1997年 | 294篇 |
1996年 | 200篇 |
1995年 | 164篇 |
1994年 | 127篇 |
1993年 | 99篇 |
1992年 | 109篇 |
1991年 | 66篇 |
1990年 | 57篇 |
1989年 | 39篇 |
1988年 | 29篇 |
1987年 | 13篇 |
1986年 | 23篇 |
1985年 | 13篇 |
1984年 | 11篇 |
1983年 | 12篇 |
1982年 | 13篇 |
1981年 | 3篇 |
1980年 | 3篇 |
1979年 | 3篇 |
1975年 | 2篇 |
1974年 | 5篇 |
1955年 | 1篇 |
1951年 | 6篇 |
排序方式: 共有10000条查询结果,搜索用时 93 毫秒
31.
32.
P. G. Muzykov Y. I. Khlebnikov S. V. Regula Y. Gao T. S. Sudarshan 《Journal of Electronic Materials》2003,32(6):505-510
To establish fast, nondestructive, and inexpensive methods for resistivity measurements of SiC wafers, different resistivity-measurement
techniques were tested for characterization of semi-insulating SiC wafers, namely, the four-point probe method with removable
graphite contacts, the van der Pauw method with annealed metal and diffused contacts, the current-voltage (I-V) technique,
and the contactless resistivity-measurement method. Comparison of different techniques is presented. The resistivity values
of the semi-insulating SiC wafer measured using different techniques agree fairly well. As a result, application of removable
graphite contacts is proposed for fast and nondestructive resistivity measurement of SiC wafers using the four-point probe
method. High-temperature van der Pauw and room-temperature Hall characterization for the tested semi-insulating SiC wafer
was also obtained and reported in this work. 相似文献
33.
通过广西水电南宁地质勘探基础工程处推行职工持股的思路,结合广西水利施工企业目前的具体情况, 就如何推行职工持股进行探讨,并提出建议及看法。 相似文献
34.
35.
新站油田大401区块裂缝治理探讨 总被引:3,自引:2,他引:1
新站油田大401区块投入开发后,通过取心观察、测井、无源微地震法监测结果和动态变化等综合分析证实,储层中发育天然裂缝。由于裂缝的存在,近几年出现注水后油井见水快、见水后含水上升快、产量下降快等矛盾。虽然通过采取定压注水、注水调整与整体调剖等一系列措施初步缓解了平面和层间矛盾,但从根本上仍未找到治理裂缝的好方法。在剖析油田存在矛盾的原因之后,对油田下步开发提出了几点建议,希望能对新站油田及类似油田的开发起到借鉴作用。 相似文献
36.
低温低渗透砂岩油藏窜流大孔道深部封堵技术研究 总被引:4,自引:0,他引:4
所用堵剂为高强度的淀粉接枝聚丙烯酰胺交联凝胶SAMG-1,由<6%淀粉、4.5%-5.5%丙烯酰胺、0.003%-0.006%交联剂组成,35℃成胶时间受淀粉和交联剂用量控制,为18-20小时以上,成胶前黏度-100 mPa.s。该堵剂具有长期稳定性,在储层岩心中注入深度15 cm的堵剂,在35℃候凝48小时后及老化90天后,封堵强度分别为0.61和0.59 MPa/cm,封堵率分别为98.6%和98.1%。该堵剂优先进入高渗层,注入0.5 PV并成胶后,2组双填砂管组成的模型低、高渗管渗透率保留率分别为68.4%、0.7%和69.4%、0.0%。吉林扶余油田西一区+15-8.2区块有水井6口,油井13口,含水率达91.5%,注入水最快在5天内到达油井。报道了该区块整体深部调剖封堵窜流通道的情况,详细叙述了+15-9.2井施工中通过注入压力和井底回压控制注入流量,使堵剂陆续进入原生和次生孔道的工艺作业,该井设计注入堵剂92 m3。6口水井整体调剖后,油井产液量差别减小,产油量增加,有效期已超过了9个月,共增油843 t,含水平均下降3.87%。图7表1参8。 相似文献
37.
The motional transition and heterogeneity of semi‐interpenetrating networks (SIPNs) based on polyurethane (PU) with carboxylic groups and methacrylic copolymer (PM) with tertiary amine groups were studied by the electron spin resonance (ESR) spin probe method. The concentration of functional groups in both prepolymers varied from 0 to 0.45 mmol g?1. Spin‐probed SIPNs show that the temperature‐dependent spectra are sensitive to polymer interactions imposed by functional groups. These interactions determine the free volume distribution in the matrix and temperature at which motional transition takes place. The fraction of free volume increases with functional group concentration and reaches its maximum at 0.25 mmol g?1. Further increases in the functional group concentration reduce the free volume. The results of the networks with strong interactions are discussed in terms of the interference of the plasticizing effect of the PU component and the formation of possible cluster cross‐links, which restricts segmental motions. Copyright © 2003 Society of Chemical Industry 相似文献
38.
介绍了用单根光纤传输测量信号和功率信号的光功率推动液体压力测量仪及其工作原理。该仪器以电容式压力传感器的δ元件作为压力检测元件,采用低功耗前置器电路和简单直杆结构,实现了便携式测量。测量范围为O~100kPa,精度为O.01kPa。 相似文献
39.
40.
磷钨酸乙醇染色法在嗜铬颗粒电镜X射线显微分析中的应用 总被引:1,自引:0,他引:1
通过比较常规透射电镜制样法、快速冷冻固定-冷冻超薄切片法及磷钨酸乙醇(EPTA)染色法在嗜铬颗粒透射电镜X射线显微分析中的应用,发现磷钨酸乙醇染色法能使嗜铬颗粒电子着色,从而较好地显示嗜铬颗粒的超微结构。同时磷钨酸乙醇染色法也以在一定程度上原位保留生物样品中元素,可以应用于检测样品元素含量的变化或比较样品元素含量的组间差别,提示磷钨酸乙醇染色法是一种可应用于透射电镜X射线显微分析的经济简便的生物样品制备方法。 相似文献